Configure your ADSL router for NTC
SPECIALLY FOR DIGICOM
- Open Internet Explorer and then type 192.168.1.1 in the
address bar. - Put admin in both username & password.
- Setup page will open & click on Network & then click on
WAN. - Default Route Selection – Auto.
- Click on Select Current ATM VC Table.
- VPI-8
- VCI-81
- Encapsulation-LLC
- Channel Mode-PPPoE
- Enable NAPT
- Enable IGMP
- Type username & password (Provided by NTC).
- Type – Continuous
- Click on Modify.
- Again click on Select Current ATM VC Table.
- Click on Save in the bottom of the page
(red color) if not Press on F11 & then click on Save. - Now you are ready to browse the
Internet.